Commands are called twice after time condition met

[wakecarter]

Do you have an ITI? If not, then maybe the whole routine is running twice without you noticing.

Add print commands

Wakefield's Daily Tips

Use Print statements When debugging, print statements can be very helpful to track down errors or unexpected behaviour. I tend to use them in one of two ways: print('trial setup started') Sometimes I won’t know where the error is, especially if there is a problem during the initial setup of the components or Begin experiment code. The components of each routine are set up in turn from top to bottom. Therefore, if you have a flow with routines called start, trial and finish and put print('tri…

Check you are using the latest code

Wakefield's Daily Tips

This is the first in what I hope will be a daily series of tips. The topic has been closed to prevent discussion. For each tip I will add a link to a thread which can be used instead. Run the latest version of your experiment When you synchronise changes to your experiment, you may need to clear your browser cache to see those changes online (using Ctrl-Shift-R, Ctrl-F5, or equivalent). If this does not work (for example because a spreadsheet has changed rather than the JavaScript files or you …